Modified on Wed, 21 Jan at 4:11 PM

Portable Electric Pump | User Guide

In this article: You’ll learn how to quickly inflate your bike tires using the Portable Electric Pump.

This Article Applies to the Following Bikes

Difficulty

★☆☆ Easy

Estimated Time

5 - 10 Min

Before You Start

Preparation

• Make sure the AirMoto is charged
• Know your recommended tire pressure (PSI), printed on your tire’s sidewall
• Park your bike on a stable surface

Watch the Full Step-by-Step Video Guide

Steps to Inflate

Step 1: Turn On the AirMoto

• Press the power button to wake the screen

• The digital display will light up
  
  

Step 2: Attach the Hose to the Tire Valve

• Remove the valve cap from your tire

• Screw the AirMoto hose onto the valve until snug (do not overtighten)
  
  

Step 3: Set Your Desired PSI

• Use the + / – buttons to select your target PSI

• Match the PSI listed on your tire sidewall
  
  

Step 4: Start Inflation

• Press the start button

• The AirMoto will automatically stop once it reaches the set PSI
  
  

Step 5: Disconnect & Store

• Unscrew the hose from the valve

• Replace the valve cap

• Power off the AirMoto and store it safely

For more information, visit the manufacturer’s website.

Troubleshooting

• Pump won’t turn on → Make sure the pump is charged. Connect it to a power source and allow it to charge before use.
• Pump turns on but won’t inflate → Check that the hose is fully threaded onto the tire valve and not leaking air.
• PSI reading seems incorrect → Confirm the hose is tightly connected and the tire valve is not damaged. Readings can vary if the tire is warm.
• Pump stops before reaching set PSI → The battery may be low. Recharge the pump and try again.
• Air leaks when removing the hose → This is normal for a brief moment. Replace the valve cap immediately after disconnecting.

FAQs

• What PSI should I inflate my tires to?
  Check the recommended PSI printed on the sidewall of your tire. Do not exceed this value.
• Does the pump stop automatically?
  Yes. The pump automatically shuts off once it reaches the set PSI.
• Can I use this on car tires or other inflatables?
  Yes. The pump supports multiple valve types. Refer to AirMoto’s website for compatible accessories and use cases.
• How do I charge the pump?
  Use the included charging cable. Charging details and indicators are provided by AirMoto.
• Why does the pump feel warm during use?
  Heat buildup is normal during operation, especially when inflating multiple tires.

Warning

⚠️ Important Safety & Liability Notice

These instructions are provided as a general usage guide for a portable electric pump. Always follow the tire manufacturer’s recommended PSI listed on the tire sidewall. Overinflation may cause tire damage, loss of control, or injury. Do not leave the pump unattended while in use, and allow the unit to cool between inflation cycles if it becomes warm.

Do not use the pump if the hose, connector, or unit shows signs of damage. Keep the pump away from water, moisture, and extreme heat. Always power off the unit and disconnect it from the tire valve after use.

MOD BIKES is not responsible for damage, injury, or loss resulting from improper use of third-party accessories. If you are unsure about proper operation or safe usage, consult the manufacturer’s official documentation. Local laws and regulations may apply.