Modified on Mon, 27 Oct at 9:17 AM

MOD Connect | User Guide

In this article: You will pair your Lumos Helmet with your MOD V3 to enable turn signal functionality.

This Article Applies to the Following Bikes

Difficulty

★☆☆ Easy

Estimated Time

5 - 10 Min

Before You Start

Tools you will need

• No Tools Needed

Preparation

• Ensure your bike is fully charged

• Ensure the Lumos helmet is fully charged
  
  

Watch the Video Tutorial

Prefer to watch? Check out our quick video guide:

Follow our MOD Connect Setup Video Guide or the steps below for a visual step-by-step of how to connect the Lumos Ultra helmet to your MOD BIKE.

Steps

Step 1: Download and open the Lumos App

On your phone, open the App Store or Google Play, search “Ride Lumos,” install, then open.

Step 2: Pair and Update Helmet Firmware

Follow the prompts until the app shows Connected. If prompted, install the firmware update to 100%, then close the Lumos App.

Step 3: Turn on your MOD BIKE

Press and hold the i button until the bike display powers on.

Step 4: Put the helmet in pairing mode

Press and hold the helmet power button for 3 seconds until the orange lights flash.

Step 5: Open the bike Menu

On the handlebar control, press + and - together to open Menu.

Step 6: Go to Setup

Use the controls to highlight Setup and select it.

Step 7: Select Bind Helmet

In the Setup menu, choose Bind Helmet.

Step 8: Select Bind New Helmet

Choose Bind New Helmet to start scanning for helmets.

Step 9: Choose your helmet from the list

Select the serial number displayed on screen.

Step 10: Confirm the connection

Look for the helmet icon next to the battery level.

Troubleshooting

• Helmet will not pair / stuck on initializing → Ensure the helmet firmware is up to date. Retry binding 2–4 times.

• Intermittent connectivity → Go back to the Bind Helmet setting and reconnect 2–4 times.

⚠️ Note: The Lumos helmet can only connect to one Bluetooth device at a time. If it is still paired with your phone, your MOD Bike will not connect.

FAQs

• Can I still use the Lumos App once I connect to my MOD BIKE?
  No. The helmet can only connect to one Bluetooth device at a time. Once paired to your MOD Bike, the Lumos App must remain disconnected.

• Can I use Lumos helmets with older MOD BIKE models?
  Only V3 models and later support Bluetooth helmet pairing. For earlier models, use the included Lumos remote.

Warning

⚠️ Important Safety & Liability Notice

These instructions are provided as a general guide for MOD BIKES products. Always ensure that all screws, bolts, and fasteners are properly tightened and secured before riding. Improper assembly or maintenance may result in damage, injury, or voiding of warranty.

If you are not confident performing these steps, please seek assistance from a qualified MOD BIKES technician or authorized service provider. MOD BIKES shall not be held liable for injury, damage, or loss caused by improper use, assembly, or failure to follow these guidelines. Local laws and regulations may apply.